170 datasets found

Tags: PHYSICAL GEOGRAPHY

Filter Results
  • AC_Chamber_6_Soil_temperature_0.05m

    Soil temperature is measured in 5, 10 and 30 cm adjacent to chamber 6 in a continous fen. The soil temperature sensors were installed in 2010 and record the temperature every...
  • AC_Chamber_3-4_Soil_temperature_0.1m

    Soil temperature is measured in 5, 10 and 15 cm adjacent to chamber 3 and 4 in a continous fen. The soil temperature sensors were installed in 2007 and record the temperature...
  • AC_Chamber_3-4_Soil_temperature_0.15m

    Soil temperature is measured in 5, 10 and 15 cm adjacent to chamber 3 and 4 in a continous fen. The soil temperature sensors were installed in 2007 and record the temperature...
  • AC_Chamber_3-4_Soil_temperature_0.05m

    Soil temperature is measured in 5, 10 and 15 cm adjacent to chamber 3 and 4 in a continous fen. The soil temperature sensors were installed in 2007 and record the temperature...
  • AC_Chamber_1_Soil_temperature_0.3m

    Soil temperature is measured in 5, 10 and 30 cm adjacent to chamber 1 in a continous fen. The soil temperature sensors were installed in 2010 and record the temperature every...
  • AC_Chamber_1_Soil_temperature_0.1m

    Soil temperature is measured in 5, 10 and 30 cm adjacent to chamber 1 in a continous fen. The soil temperature sensors were installed in 2010 and record the temperature every...
  • AC_Chamber_1_Soil_temperature_0.05m

    Soil temperature is measured in 5, 10 and 30 cm adjacent to chamber 1 in a continous fen. The soil temperature sensors were installed in 2010 and record the temperature every...
  • AC_Active_layer

    Active layer is measured in the vicinity of the Automatic chambers in 'Rylekæret' in the Zackenberg valley. The reported active layer depths are in relation to the ground...
  • T5_Air_temperature_0m

    Air temperature is measured in 0 cm on the top of the mountain 'Dome'. The measurements were initiated in 2004 and ended in 2006. Temperature was recorded every hour. Blank...
  • T4 Air_temperature_0m

    Air temperature is measured in 0 cm on Nansenblokken on the eastern slope of Zackenberg, in 480 meters above sea level. The measurements were started in 2002. Initially the...
  • T3 Air_temperature_0m

    Air temperature is measured in 0 cm on the top of the mountain Aucella. The measurements were started in 1995. Initially the temperature was recorded every fifth hour, until...
  • T2_Air_temperature_0m

    Air temperature is measured in 0 cm in the eastern end of 'Store Sødal'. The soil temperature sensors were installed in 1995. Initially the temperature was recorded every fifth...
  • T1_Air_temperature_0m

    Air temperature is measured in 0 cm near the old trapping station 'Blæsenborg', in the area 'Morænebakkerne' Northwest of the Zackenberg station. The soil temperature sensors...
  • MM2_Precipitation

    MM2_Precipitation
  • MM2

    Micrometeorological monitoring has taken place at the site MM2 since 2009. In 2011 an energy balance mast was put up about 10 meters West of the existing eddy covariance mast....
  • MM1

    Micrometeorological monitoring has taken place at the site MM1 since 2000. In 2011 an energy balance mast was put up about five meters East of the existing eddy covariance mast....
  • M8

    The meteorological station M8 was installed in 2015. M8 is located about 100 meters from the top of Zackenberg. The ground underneath the mast is covered with barren rocks and...
  • M7

    M7 is one of six meteorological stations in the Zackenberg and Store Sødal Valley, where M7 is the only station in Store Sødal. Data from the station is found under...
  • M6_60min

    "The meteorological station M6 was in function from 2006-2012. M6 was located near the top of the mountain Dome. The surface underneath the mast is a gravel plateau without...
  • M6_180min

    "The meteorological station M6 was in function from 2006-2012. M6 was located near the top of the mountain Dome. The surface underneath the mast is a gravel plateau without...
You can also access this registry using the API (see API Docs).